MSD distributor W/ Tri-Power

[Russ348]

Will the new MSD Distributor designed for the 348 work with a
Tri-Power setup. I already have both but need something to worry about.
The car, 60' 349 Impala. Thanks in advance.

 

[hotrod 409]

MSD w/tripower

Late in replying to your question, been very busy with my business thar funds my passion for cars.
I currently am building a 1931 F**d street rod highboy powered by a low HP 409, cast iron 3/2 intake with show car carbs, linkage, air cleaners, also MSD distributor. Fired engine last nite for first time (what a thrill with open headers) so far works fine although I haven't driven car yet. Engine is all set-up (dialed in timing, adjusted center carb idle, checked vacuum advance). Will know better about progressive linkage after I drive it. Hope this reply helps
Regards
hotrod 409

 

[Russ348]

Thanks Hotrod 409. Guess then the answer would be YES. Seems
your setup will be very similar to mine.

Russ

 

[Fathead Racing]

I run with the MSD ready to run dist. with three twos, no problem.