Hey guys,
Looking for some ideas or opinions on what I should do for a rear sway bar on my 58 Impala. Frame has been back-halved, narrowed over the axle, triangulated 4 link installed and 9" narrowed with provisions for coilovers. Obviously a lot has changed back there and a traditional sway bar setup isn't going to work. I apologize for the crappy pics, as I took most of them on my back under the car without much room. Any ideas as to where to attach to the 9"(it seems most of the room is dominated by brackets for 4 link and coilovers) and the frame? I'm assuming I may have to have Addco, or someone, custom build one, but I'm just hoping someone has had a similar situation and can give direction. I should also add, that id like to accomplish this without welding...just drilling, if possible. Thanks, Josh
Looking for some ideas or opinions on what I should do for a rear sway bar on my 58 Impala. Frame has been back-halved, narrowed over the axle, triangulated 4 link installed and 9" narrowed with provisions for coilovers. Obviously a lot has changed back there and a traditional sway bar setup isn't going to work. I apologize for the crappy pics, as I took most of them on my back under the car without much room. Any ideas as to where to attach to the 9"(it seems most of the room is dominated by brackets for 4 link and coilovers) and the frame? I'm assuming I may have to have Addco, or someone, custom build one, but I'm just hoping someone has had a similar situation and can give direction. I should also add, that id like to accomplish this without welding...just drilling, if possible. Thanks, Josh