What do call & where can you purchase something that will work in its place.

[ROYALOAK62]

On the firewall there were 3 CLIPS that are bendable that the wire harness slips into, one of mine broke off.
They act like they are made of SOLDER like material as they are easily bendable.
Anyone know what I can use its place ?
Haven‘t found at my local parts place or hardware store.

Dave

 

[La Hot Rods]

I think they are just mild steel. Being spot welded to the firewall is would take paint work to finish the replacement.

 

[409gang]

You could make a clip out of sheet metal, carefully clean a spot on the firewall and use panel bond to put it on. After it cures use touch up paint and a small brush to color the same as the firewall. If the metal is clean on both sides you will not be able to pull it off without tearing the metal.

 

[ragtp66]

I used these to hang my under dash wiring. VERY strong and if I need to work on anything I can pull it down.
https://www.summitracing.com/parts/tnl-62417-4

 

[blkblk63ss]

If you want more original look just cut strips of light weight guage sheet metal lenghts that are same lenght and width of original drill hole one end and either screw or pop rivet to vehicle. Can paint before puting on . You can round off corners for same as originals. Make them long enough so when you fold them they are as long as originals.