Lightweight lover
Member
I first removed the side moldings and replaced them with a set of NOS mouldings that I had stored. Then we started installing the windows and interior.
Is the casting date inline for a Z car?The block had been milled so I’m going to attempt to raise the stamping with an acid solution. The block was drilled for 4 bolt main caps yet the motor hasn’t been into since early 80’s. The only lightweight component needed is the lower grille panel. The fenders on the car are the Hayden Proffitt fenders from the original car I’ve been told.
I was able to pull one that way a couple years ago. Probably really matters how deep the milling was. I had to apply it about 6 times but it did appear.I tried raising one with muradic acid. No luck.