Hayden was at the Texas Motorplex in Ennis Texas many years ago and had a table set up for a meet and greet. He had a bunch of original GM HP intake valves that he was selling for $7.00 each. He gave time to anyone who stopped by and answered all questions. A classy guy.
Yes, the balls are with the respective rocker arms that they were on the head with. I removed them from the heads and immediately put them on the wire together.
I have these two sets of GM rocker arm sets. They have minimal wear and would not need anything other than cleaning before installation. The nuts on one set have a smooth taper on the top and the other set has a stepped taper on the nut. $100 per set plus shipping.
I have a solid lifter 454 LS6 cam in my GMC Sprint. I cut the top off of a distributor cap and tap the engine over watching the rotor as it goes to each cylinder in the firing order, adjust those valves, then go to the next one. After a full revolution of the rotor, I am done. I do it cold...
How to make Electric Brakes operate properly:
1. It is important for all the brakes to be adjusted the same as close as possible. A good way to adjust drum brakes is to tighten them up while spinning the tire and wheel assy until they are locked up. This centers both shoes in the drum. If you...