Recent content by lilbuzzy

Are there any photos of the intakes he has made?

if you are serious, I know a guy :brow

understood. if it is the exhaust passes under the drive shaft down the center. thanks for responding. cant wait to see it done.

nice stuff. will the exhaust stay inside the frame or are there ports/holes in the rails for it to exit toward the outside of the frame? is that a roadster shop frame?

well, my blaster is mobile....

next, i took one of these and did this to it

these are probably the most structural part of this car. no less than 8 spot welds on each just to get the floor pan out. i save them for last. this is what they were attached to

didn't look for it. car was an 327 3 on the tree.

Mo no flo and for you mr. reed.....

back at it. no mo flo. now we got flo.

Just found out about this today. I may be late to this goat ropin but there are some brand new old impalas. I think we are going if at all possible. Moderator please move or delete if this is in the wrong place. Check it out: http://www.youtube.com/watch?v=rRFiSUH4gdQ

20ish. lots of parts. probably take that much to finish it.

62 bbl top original small blk car. Body not done. Had quarter replaced. No floor/trunk rot. Has complete done chassis with 409 4spd. I know condition is everything. I have yet to go look at it so I cant validate the claims of the owner. I have seen real 4o9 cars shoot the moon. what do...

absolutely! don't shoot the messenger! just got my email inviting me to purchase as i inquired about these three years ago. i am waiting to see how bob's blocks work out. i want one really bad. just can't pull the trigger at the moment.

http://www.theengineshop.com/products/bmp-409-inchwinch-block.html