RPOLS3's latest activity
-
No return line to the gas tank from the engine on 1962 factory 409 cars (return lines started on 1963 factory 409 cars All 1962 409... -
RPOLS3 replied to the thread Holley red fuel pump.SOLD
-
It depends on what you have already.If you are using the factory routing the left and right are different.I don’t know how correct you...
-
RPOLS3 reacted to Gliderider06's post in the thread Fitting to run mechanical temperature gauge and dash light with
Like.
I used a black iron tee and short nipple on my Edelbrock intake. -
RPOLS3 reacted to kiwi's post in the thread Fitting to run mechanical temperature gauge and dash light with Like.
I used the back expansion plug by the oil filter good location to run wire inside with factory holes in firewall. Purchased a nut the...
-
RPOLS3 reacted to Jerry B's post in the thread Fitting to run mechanical temperature gauge and dash light with Like.
I also used a tee at the heater hose fitting.
-
RPOLS3 reacted to skipxt4's post in the thread Fitting to run mechanical temperature gauge and dash light with Like.
Years ago, I believe it was Eckler's LGC, sold a Freeze-Plug with a fitting to install a second Temp. connection.
-
RPOLS3 reacted to JWahlstrom's post in the thread Fitting to run mechanical temperature gauge and dash light with Like.
I've used a tee with a heater hose fitting when no extra tapped holes were available. I didn't want to lose the dash lights, either.
-
RPOLS3 reacted to Skip FIx's post in the thread Fitting to run mechanical temperature gauge and dash light with Like.
Either a tapped thermostat housing or drill an tap another hole in the water crossover.
-
RPOLS3 reacted to Murphdog's post in the thread Fitting to run mechanical temperature gauge and dash light with Like.
The 881 location you mention is all there is to my knowledge. Gm used some thermostat housings with some npt openings for ported vacuum...
-
RPOLS3 posted the thread Fitting to run mechanical temperature gauge and dash light in 348 and 409 Engines.Trying to install a period correct mechanical S-W temperature gauge and still run the factory temp lights in the dash in a 62 409-409...
-
729720 Gabriel Hi Jacker Air shocks with lines - complete setup. From what I can tell via internet searches this is a universal set...
-
-
RPOLS3 replied to the thread 63 409 Starter Removal + Exhaust.I just did this on our 62 a few weeks ago. I swapped out a generic block mounted starter for a correctly dated bellhousing mounted...
-
-
RPOLS3 replied to the thread Seat belt restoration.Another vote for Snake Oyl here
-
RPOLS3 reacted to Barry Taylor's post in the thread Late Great Chevys monthly publications No More? with Like.
Been a long time since this was posted! Thought some of the newer members might like it! Ronnie’s first 409 car a 63ss with a truck...
