Am in need of 12 bolt complete, aftermarket rear end for 62 Chev. Found sources for 9 in Ford, but not Chev 12 bolt. Any suggestions?? Thanks.......
we have been using Moser just because they're right up the road from us. they have some good prices on complete assemblies. i know they will not fab. a 12bolt hsg. for our cars. they don't like the idea of welding the upper brackets to the center section casting. i know it can be done but you may run into the problem of warping the casting and end up with bearing problems down the road. i have been tooling the idea around of somehow using the chevelle hsg. in our cars? we have always wanted to move the upper brackets up for better traction control, maybe a bracket could be made to use the chevelle hsg. ????
I am using a 12 bolt from a 67 impala. Had the bracket welded to the center section. No problens yet. (knock on wood).
They all sell F-9" or the Dana. Lots of fit problems with the 12 bolt and the ears on the center section. F-9" requires you to cut away part of the driveshaft tunnel for the lower pinion position. Are you going racing?