1964 Chevy c10 short box fleet side with the big back window.
It's a really solid project truck. I crawled all over it and under it too. I could only find 3 little rust holes
that I think could be fixed very easily. One is on the floor on the passenger side. One is in the right rear cab corner and the other is on the driver side along the kick panel. There was one dent behind the rear wheel about half way up the fender
that might be a little bit of a challenge. There is no crease in the dent and it's not in the body line. It's about 10 inches long and 2 or 3 inches wide and about 1/2 inch deep. It has a older 350 sbc and a 3 speed Muncie. (floor shifted)
It does not run or drive at this point. The owner purchased a new gas tank to put under the bed between the frame rails. (It has not been done yet) The seat is missing and the rear wheel wells are missing too. The box is sitting loose on the frame.
I live in the Midwest and this would be considered a rust free pickup!! I was told it came out of AZ.
He's asking $4000. I only have one picture of it and it's not a good one. I don't want to post it unless I buy it.
The whole truck has been sanded on. Some spots are bare metal and some are not.
What's the going rate for a nice project C-10?
It's a really solid project truck. I crawled all over it and under it too. I could only find 3 little rust holes
that I think could be fixed very easily. One is on the floor on the passenger side. One is in the right rear cab corner and the other is on the driver side along the kick panel. There was one dent behind the rear wheel about half way up the fender
that might be a little bit of a challenge. There is no crease in the dent and it's not in the body line. It's about 10 inches long and 2 or 3 inches wide and about 1/2 inch deep. It has a older 350 sbc and a 3 speed Muncie. (floor shifted)
It does not run or drive at this point. The owner purchased a new gas tank to put under the bed between the frame rails. (It has not been done yet) The seat is missing and the rear wheel wells are missing too. The box is sitting loose on the frame.
I live in the Midwest and this would be considered a rust free pickup!! I was told it came out of AZ.
He's asking $4000. I only have one picture of it and it's not a good one. I don't want to post it unless I buy it.
The whole truck has been sanded on. Some spots are bare metal and some are not.
What's the going rate for a nice project C-10?