Ok gang. My OCD is really screwing me up on this one. So I need to run 5/16 hardline from my stock, mechanical fuel pump to rubber line/filter. However, I can’t get bends tight enough with tubing to miss the lower radiator hose. Soooo I’m thinking installing a 90 degree, pointing up, to make it easier, right?But I can’t figure out the elbow I should use!!
The pump has an inverted flare, looks like a 1/2-20 straight thread, for a 5/16 tube. So I’m assuming the elbow would need the same outlet, but what about inlet? An NPT? A straight thread?
These are the stupid things that keep me away at night.
The pump has an inverted flare, looks like a 1/2-20 straight thread, for a 5/16 tube. So I’m assuming the elbow would need the same outlet, but what about inlet? An NPT? A straight thread?
These are the stupid things that keep me away at night.
Attachments
Last edited: