Hi Guys,
What are the issues in putting screw in studs in W heads?
I have done SBC etc in the mill at work in the past but was going to get a local machine shop here to do these for me.
Are there anythings to watch for, how much of the boss should come off to get roller rockers under tin covers?
Is it a case of suck it and see or is there some measurements out there?
3/8 or 7/16 your opinions?
Steve
What are the issues in putting screw in studs in W heads?
I have done SBC etc in the mill at work in the past but was going to get a local machine shop here to do these for me.
Are there anythings to watch for, how much of the boss should come off to get roller rockers under tin covers?
Is it a case of suck it and see or is there some measurements out there?
3/8 or 7/16 your opinions?
Steve