I do have a question for you guys, how do you know if you've installed your steering box and shafts correctly?. I read there is a
shim you can use on the box itself to straighten the angle, but have not put that on yet. When we first started up the motor a couple
months ago, we had some trouble with gas leaks, and also needle & seats, that fixed they started it up again, and it ran fine for
about 15 - 20 minutes then the bearing on the Idler pulley started blowing out grease, also the lower bearing on the column went
bad. The pulley could have been a misalignment issue with the other pulleys, I did replace that bearing and took more time to
make sure the pulleys all lined up, water pump pulley and crank pulley.