Hi everyone. I'm not sure I previously mentioned it, but the signal light lever and internals have always been sloppy, and they got even sloppier if that is possible. They would work about half the time if you played with the lever. They progressed to the point where presently they don't work at all. Took the steering wheel off today and took a peek. There is a screw holding a shifting plate down and that was loose so I tightened it. I tried the lights; still negative. I looked in my repair and assembly manual for a schematic but couldn't find any. I kept looking at the internals and saw the tiniest cable I have ever seen. Saw that there was a loop at the end which went to nothing. Looked further and saw an arm that I thought this cable was suppose to be attached to, had slid off. Reattached it and one side of the signal lights began working. Continued fooling with it and then the other side would work. Went back to the passenger side and nothing. You really had to move the lever gently to get anything to work. Even then it was no guarantee. Sometimes nothing worked at all. I ordered a repair kit with a new shifting plate that I need. Seems that there is a pin that pivots in a hole on the plate that is partially wore out. There is also a small nylon bushing that I don't think fits correctly either. I will install the new kit when it arrives. Not sure why, but I think part of my problem is in the lower switch that is controlled by that tiny cable and the shifting plate. Tomorrow, I'm going to take the one cable end off as I found it. I'm going to regulate the cable with needle nose pliers and see if I can get the lights to work independent of anything else. Everything appears to be mechanical; no wires that I could see, so this should be a good test. I can buy the lower switch if need be and a new cable. Just wondering if anyone has every replaced the lower switch and cable before?? Thanks, Carmine.