Nice work
Stan,The rear fender housing is I believe a (2) part section, outer and inner.
Mine like many was rusted at the fender well, so I bought both the panels needed. The main problem is I had no idea of how they were
attached except I knew they were spot welded, as I could see all of the weld marks. I did not know what the bracing looked like under neath the panels, that would have been really nice to know before hand.
As they don't make the piece for the upper inner rear fender that I cut out, which I shouldn't have. I now have to try and piece back the pieces i saved to make a patch panel and hope it works. This is where beginners like myself get into trouble, they don't really know what to take off, and how much of the part to take off or leave on, to get the job done right. I have had a lot of help from Jim and Dennis Bupp and others, which really helps, and the many good natured humorous comments from yo'all. blkblk63. said, it looked Iike i was having fun!
well, Im not sure that is what I would calls it, but it is something to do.
Learning as I go. 348-409 school #101. cash