sycsteve
Well Known Member
Yesterday was the day Jim and I have been long waiting for. The day we finished painting this project 62 Bubble Top. This was Jim's very first paint job that he used a Base Coat-Clear Coat. We both learned a few things as we went, but when all was said and done, it turned out pretty darn nice. When all of the color sanding and buffing is completed it should look better than factory....Can't wait to get started. I need a little help before installing the headliner. Can anyone help me choosing the correct inside roof insulation to be used . I had to remove all of the factory insulation, as it was hanging down in most places. I believe the factory insulation was about 1/8 inch thick. Is that about right. So I would need the new replacement insulation to be close to that or a little less to make the headliner fit properly. I was looking through Hubbards Cat., and I see that they have a peel and stick , that is marked NEW, but it does not say how thick it is. Any help and input would be greatly appreciated.
I have been looking for insolation myself. I have been looking at Fat Mat or Dyna Mat for my floors. Looked at Lizard Skin but its pricey.
Found this stuff that may work well for the roof. I sent it back before I thought of using it for the roof. No adhesive backing and has thick bubble wrap between the foil layers. It's about 1/4 thick.
http://www.ebay.com/itm/161878165008?_trksid=p2060778.m2748.l2649&ssPageName=STRK:MEBIDX:IT
Think this would be good for the floors for me.
http://www.ebay.com/itm/190736901235?_trksid=p2060778.m1438.l2649&ssPageName=STRK:MEBIDX:IT