Recent content by 60convert

bad checks if you have a bad check and you do buisiness at a level where you could blow that check up with the stamp on it that says it was returned I would do so and anythime I was at a swap meet or anything like that I would tape it so that everyone could see it. One time I was at a...

wow fran wow fran i have been busy and havn't been on this board in a long time, i very suprised at how you tell someone you don't even know what to do. from whet i have read i believe both you and your wife race, don't you do it for fun and for the challenge. One thim my dad tought me is when...

yep yea those are the ones i was just wandering if they mant anything more than it was an impala or???? Jesse

looking at the 6 2bbl set up if you look at the other auctions there is a 60 convert in there for sale and i was wandering what the 4 pieces that are on the front part of the fender. Each one goes fron to back and then they are placed one above the other on the front part of the front fender...

well somewhere it is bleeding of the pressure. if the system is staying full and over filling the over fill then its the cap if the overflow doesn't change then you have a leak somewhere else in the system. the cheapest would be to toss on a different cap and go from there. Jesse

on the other hand my brother once bought a t-top cutlas 84 I belive out of a yard it had only been there for like 3 mo so maybe the paper work hadn't been sent into the state??? maybe if you are quick enough you can still get a title and eveything from the yard. or at least if not a title, it...

hey for the 99.95 does that mean you have to wipe the grease off the car as i am sure they are not masking of using paper and tape. wash the car off apply grease and paint and if there isn't room inside paint outside???? customer wipes grease off lol??? and what kinda paint are they using...

parts store I am lucky enough that in jordan theres a napa and they guys there are pretty good when i ask for weird stuff he always askes what I am building, and if i ask for small block v/c gaskets he actually knows that all you have to do is punch in an older car with a small block in it. My...

wow you did such a good job that a miral of a 62 apeared in the paint. actually you did one h@ll of a job and it was a good tip as i have a few spots to do on my girls car but they can wait a while as it is a plastic saturn. Jesse

why are you leaving??? back this winter??? stay a while and learn what you can till you actually get it that way you can learn the tricks, thats what I am doing till i am able to get my first W. Jesse

bolts i am not sure how much room is in there with a w in there but if there is room you can put a nut on the threads to keep from damaging them then tap it out from the engine side. but like i said i am not sure how much room you have. Jesse

give it a tune up, probally replace the intake gaskets as they are common to leak then use it as a daily driver. oh and change the oil every 3000miles how ever many km that is. you abuse that car with that many miles on it and it will die a quick death. Jesse

hey bob one that my dad tought me on a broken lens use red battery sealer on the bulb it always worked for me. Jesse

what about using an adapter for a cylender pressure test tool it all ready has a quick disconect all you would have to do is find a female at the parts store and get another male that will hook to your air supply as they are usually different than the ones you already have would be a lot...

I would start by swapping back to the 1.5s to see if that gets rid of the noise at least then you know your cam lifters and push rods are the same. Then after that if its quite i would swap 1 set of the 1.6s on at a time and see where the culprit is otherwise mayber there is interferance with...