I don't see how that's possible unless smaller end of throw out bearing is on backwards. I could be wrong . Is it the correct bearing???The finger on the pressure look like the are past the release bearing. You need to start over if you were just replacing the the release bearing.
Ok, I just can't imagine the bearing going past fingers of pressure plate .The larger end is next to the pressure plate, the through out bearing is same size as the old one.
What does the pressure plate look like?? Does it have small pointed fingers all the way around or the three lever type like racing .I got it on correct there was even a picture in the box to show how it goes.
Don't have to pull bell to see.As I remember yes but I may have to pull the bell housing off and have a better look.
Yeah, something looks REALLY odd there. It does appear the bearing is going inside the pressure plate fingers ???The finger on the pressure look like the are past the release bearing. You need to start over if you were just replacing the the release bearing.