Update on BA 409
- Thread starter Tom Kochtanek
- Start date
Okay already its gone.
So what are you guys calling stock axle flange to flange for a 62 ?
And pinion centered, sure would save me from having to jack up and remove rear wheels again.
And pinion centered, sure would save me from having to jack up and remove rear wheels again.
Think you may go too fast without one James??? I thought it would be more like a Jake brake.................
Last edited:
You never know.
But more than likely I will need one on the front so you guys can suck me down the track.
Soo whats the verdict on the width on the stock rear?
Thinking this bad boy is fixin to get trimmed.
Thinking this bad boy is fixin to get trimmed.
I understand completely and then you would wonder why you would want it stock.
I was around 60 inch's when I was roughing it in but I need to only do this once.
I am not confident with my first reading.
I am not confident with my first reading.
I found this info James, don't know if it will help. http://www.348-409.com/forum/threads/rear-end-width-chart.2645/#post-24770
Thanks sounds like 60 inch's.
I was there to 60 1/4
This poor rear end had no idea of what it was in store for.
I found the directions.
Little update.
I cut off the housing ends and put them in the lathe to turn down the welds for a nice clean end to install.
I cut off the housing ends and put them in the lathe to turn down the welds for a nice clean end to install.
I bet my wife will love me for that.
Yeah then the house will smell just let you...
Tell her you found a new oven cleaner and want to try it out....
